Gripnail Rolling Head Pinspotter
Continuously Line 5-Foot Wide Ductwork
The new Gripnail PowerPinner 7105HS boasts the quickest cycle time and most reliable welds available. Functioning without any mechanical reeds switches, the 7105HS on-board computer has been turbo-charged for peak performance.
The new PowerPinner 7105HS boasts the quickest cycle time and most reliable welds available. Thanks to a technological breakthrough, the 7105HS high speed welder is built with the same high quality materials you have come to expect form Gripnail. Functioning without any mechanical reeds switches, the 7105HS on-board computer has been turbo-charged for peak performance. The new Programmable Logic Controller produces welding speeds never before seen without sacrificing welding quality.
Contractors who regularly line large fittings and straight duct will find the convenience of the 7105HS speeds their assembly and reduces fabrication costs. The weld head ravels a full 60 inches for lining 5-foot wide duct. The head is moved with a multi-position extension arm and glides on specially designed bearings, while all wires are reinforced in a wire sleeve and securely housed in an energy chain.
At 83 cyucles per minute, the new PLC reaches coil line speeds.*
Depressing the ergonomic foot pedal while the Continuous Fire switch is on allows the operator to continuously weld pins without having to lift their foot off the pedal.
High Capacity, Split Weld Pin Track System
Upwards of 25 pins are available from the lower track before additional pins are speed loaded from the upper track.
High Output Transformer
Produces the strongest possible welds for 1/2″ all the way to full” pins fastened to 16-26 gauge sheet metal.
- Air Requirement: 2-3 CFM, 80 PSI
- Working Depth: 60″
- Anvil Height: 36″
- Total Depth: 71″
- Total Width: 32″
- Input Voltage: 190-240 VAC 60Hz, 1PH, 35 Amp
- List Weight: 681 lbs
- Shipping Weight: 767 lbs.
Only logged in customers who have purchased this product may leave a review.