Norlok Little Lok 1200 Fastening Machine
Norlok the Letter Lok "Little Lok" 1200 fastening machine has been designed for fastening channel letters. It has a 12" throat and can accommodate a 6" return.
- SKUHVAC NLLFM
- Clinching Machines
- HVAC
- 12" Throat, 6" Return
The LetterLok ‘LittleLok’ 1200 fastening machine has been designed for fastening channel letters. It has a 12” throat and can accommodate a 6” return.
With the ability to fasten up to a 6” return and its ease of use the LittleLok 1200 can make short work of your channel letter fastening needs.
The LittleLok 1200 represents the next generation of LetterLok machines. Whether it is your main fastening machine or a sibling for an existing LetterLok, the LittleLok has the features you need. You will have the peace of mind of knowing you have a machine that was designed and built by the company that sets the standard for the channel letter industry.
Features:
- 12” throat
- Accommodates a 6” return
- Operate at 60-80 cycles per minute
- Maximum combined material thickness of 0.125”
- 100% air powered
- Adjustable table
- UL recognized clinch for channel letters
UL Recognized
UL’s Component Recognition Service covers the testing and evaluation of component products that are incomplete or restricted in performance capabilities.
These components will later be used in complete end-products or systems Listed by UL. UL’s Component Recognition Service covers millions of components, such as plastics, wire and printed wiring boards, that may be used in either very specific, or a broad spectrum of end-products, or even components such as motors or power supplies.
These components are not intended for separate installation in the field, they are intended for use as components of complete equipment submitted for investigation to UL.
| Press Design | 3” Solid steel “C” frame. |
| Features | WAMP pneumatic power unit. Single shot auto return. |
| Stroke | 3 1/2” low pressure closing stroke 1/4”-3/8” high pressure clinching stroke |
| Throat | 12” |
| Table | 18” deep x 34” wide |
| Work Height | 44” |
| Lower Tooling | Die insert set in a hardened die holder. |
| Upper Tooling | Fast change punch Replaceable punch stripper Adjustable to suit material thickness. |
| Capacity | MAX: Combined thickness of 0.125”. MIN: Two ply 0.024” Aluminum. MAX: Two ply 0.040” Mild Steel. MIN: Two ply 0.015” Mild Steel. |
| Cycle speed | Clinching stroke 60 – 80 CPM. 100% duty cycle. |
| Air Requirements | 65 psi (operating) 125 psi (max supply) 80 psi (min) Approx. 12-13 SCFM @ 65 PSI. (80 clinches per minute) |
| Dimensions | Width 36” (overall) Length 34” (overall) Height 74” (overall) Weight 700 lbs. (approx.) |
Typical Joint Strengths (Aluminum):
| Material Thickness Punch side / Die side | Pull (lbs) | Peel (lbs) |
| 0.063 to 0.063 | 240 | 72 |
| 0.063 to 0.040 | 270 | 50 |
| 0.040 to 0.040 | 175 | 60 |
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.